Replying to @toni #SkateSkins Install Instructions: - Make sure skates are cool & dry. - Starting with the back of the skate, peel off the adhesive backer. - Line the bottom, middle of the SkateSkins up with the heel cap on back of skate. - If no heel cap, start about 2" from the bottom of the skate, in the back. - Carefully start to install the sides to the skate. - If SkateSkins need to be repositioned, (refer to removal instructions). - Install higher or lower on the heel cap and repeat install steps. - Once fit is good, firmly bond all areas of the SkateSkins to the skate by hand. - DO NOT use heat on SkateSkins or bake skates with SkateSkins on. - Ensure all edges are properly sealed to avoid any lifting. No wait time needed. #SkateSkins Removal Instructions: - SkateSkins should always be removed from the front. - Removing from the top could cause damage to the skins. - IMPORTANT: Grab the toothpick (from the bottom of the packaging). - Use the toothpick to get fully under the fro...