Witch Hat *PATTERN ONLY TUTORIAL*👇🏻 🖤Step 1: You need to find the circumstance of your head! This will be the number you use for the base and cone. Mine was 21.5 but I went to 22 to be safe. You then need to find your radius ( circumference divided by 2 x pie ) If y’a want to skip all the math you can wing it and use my measurements! • 🖤Step 2: Let’s make our brim, cut an 18x18inch square. (If you want a bigger brim go up in inches, smaller go down) Fold in half, then fold in half again to make a square. • 🖤Step 3: Let’s turn it into a circle, start at the fold and go down nine inches, make a mark. Keep sliding your tape measure and make little ticks so you can draw out your even curve. Cut on that line! • 🖤Step 4: Let’s use that radius, this is going to be your hole for the cone. Measure from tip to your radius number (3.5 is mine) and make a mark. Same as before make little tick and draw out your curved line. Cut on the line. • 🖤YOU FINISHED THE BRIM🖤 • 🖤Step 6: Cut 15 x (yo...